I am not starting this project until the spring due to shop space restrictions, but I have a 3.0L Stroker M20 motor (19Ibs Injectors), done by PO via the Ireland Engineering kit. Planning on installing it an manual trans in my E30 Cabriolet.
Plan is to use Miller Prostreet Induction Kit for MAF Conversion along with WAR Chip, and currently thinking best starting point from the ECU173 Tune Cache would be this:
"173 G3 Miller Stroker base (19Lb) 2-8L+.mpc
Gen 3 MAF performance tune using the 3" MAF housing and 19lb injectors for a 2.8L stroker motor"
Sound good? Or better to start with a stock 2.5L Tune and have a shop or Miller do complete custom Tune for it? Previous Owner had the 3.0L running in an E30 but just on stock 2.5L ECU, causing it to run a little rough and dirty, but stable. Just looking to clean it up a little when I swap it in