Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

General Discussion / Is there any injector select table?

« on: April 04, 2015, 05:30:36 PM »

Is there any injector select/adjust table on the software? or we have to pay to have that part done if we decided to change injector size?

i don't see any injector flow rate or offset vs volts etc.

Thanks,
Jon.