1
Naturally Aspirated Tuning / 404DME M60B40 idle fuel not responsive to tuning.
« on: October 05, 2015, 02:33:24 PM »
Hey Guys,
Interesting issue here, I just installed a set of BoschIII EV1 24lb injectors in my M60. I brought in my Miller WAR chip loaded 404 DME into the house and plugged in to my Windows XP desktop, like I've done since installing the chip. I set up a series of 4 tunes with progressively leaner idle fuel tables to find my starting point for the new injectors. (all four tunes loaded with O2 sensors turned off).
I fire up my first tune, idles at 10:1 AFR (Innovate MTX-L wideband gauge and sensor installed). I click to the next tune which I made 20% leaner then the original...still 10:1 AFR. Third tune, 25% leaner...10:1 AFR. Fourth tune, 30% leaner...10:1 AFR. So as an experiment I write a tune that has 150% richer then OE and then a tune 75% leaner then OE, and finally I just zero out the idle fuel tables all together and loaded the tune....no matter what the tune says the idle stays at 9.8-10:1 AFR. Before, with the Bosch Gen II 19lb/hr injectors idle AFR's were high 13's/ low 14's but I didn't previously spend any time dialing in idle fuel.
As a side note, the AFR's and fuel delivery is responding to the main P/T fuel tables as I can lean or richen them out via tunes.
I'm going to try a program uninstall. Make sure java is fully updated and then do a full re-install to see if that helps. I'd really like to get idle AFR's dialed in, car is practically undriveable as is.
Also, is there any way that I can turn off deceleration fuel cut-off? It's causing some light load, light accelerator pedal cruising issues. Thank you.
Interesting issue here, I just installed a set of BoschIII EV1 24lb injectors in my M60. I brought in my Miller WAR chip loaded 404 DME into the house and plugged in to my Windows XP desktop, like I've done since installing the chip. I set up a series of 4 tunes with progressively leaner idle fuel tables to find my starting point for the new injectors. (all four tunes loaded with O2 sensors turned off).
I fire up my first tune, idles at 10:1 AFR (Innovate MTX-L wideband gauge and sensor installed). I click to the next tune which I made 20% leaner then the original...still 10:1 AFR. Third tune, 25% leaner...10:1 AFR. Fourth tune, 30% leaner...10:1 AFR. So as an experiment I write a tune that has 150% richer then OE and then a tune 75% leaner then OE, and finally I just zero out the idle fuel tables all together and loaded the tune....no matter what the tune says the idle stays at 9.8-10:1 AFR. Before, with the Bosch Gen II 19lb/hr injectors idle AFR's were high 13's/ low 14's but I didn't previously spend any time dialing in idle fuel.
As a side note, the AFR's and fuel delivery is responding to the main P/T fuel tables as I can lean or richen them out via tunes.
I'm going to try a program uninstall. Make sure java is fully updated and then do a full re-install to see if that helps. I'd really like to get idle AFR's dialed in, car is practically undriveable as is.
Also, is there any way that I can turn off deceleration fuel cut-off? It's causing some light load, light accelerator pedal cruising issues. Thank you.