Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

WAR Software Support / Re: no start issues

« on: July 21, 2014, 01:49:09 PM »

yeah i tried both chips on both the ecu's and the same problem recurred so ill give them a call when i get some time on my hands. thank you again for taking the time to walk me through the troubleshooting process! Ill post again after i talk to tech support and possibly get her running!

2

WAR Software Support / Re: no start issues

« on: July 20, 2014, 01:52:25 PM »

ok so i added three of the same tunes, then adjusted the cranking fuel on one 5 increments down, five increments up on another, and kept the third as a baseline. the baseline was the only one that would start but not after much cranking. at this point i'm out of my element and might just take it to a pro to get it tuned. know anybody in california san jose bay area?

3

WAR Software Support / Re: no start issues

« on: July 20, 2014, 01:11:58 PM »

i just uploaded 4 s50 tunes and she still cranks. after maybe 1 minute of cranking ( 5 sec intervals with cooldown time plus batt charger) it will start with no preference to any tune. right now i'm using : #1; s50 24# 3-5 maf, #2; s50 performance, #3; s50 s52 3-5 maf 24#, #4; s50 s52 3-5 maf 24# w cams. tune #4 runs the best but they all wont start the car

4

WAR Software Support / Re: no start issues

« on: July 20, 2014, 11:37:39 AM »

i rebuilt the engine maybe 5,000 miles ago and thats when i put the cams in, since then its been running on the 413 ecu with a Turner chip for the maf and injectors. it runs with the Turner chip but when i swap the miller chip in all i get is cranking. then i swap them back all is right with the world. luckily i have access to another obd1 m3! i just swapped ecus with the other m3, first i tried it with the Turner chip (started right up) second i tried the miller chip ( started after much cranking ). this time i had a few cylinders fire and it eventually stumbled and started up and ran fine afterwards. im going to try to re-upload the tunes using a different xp computer

5

WAR Software Support / no start issues

« on: July 19, 2014, 06:25:38 PM »

i recently installed the war chip as the directions instructed, i had a few problems getting a base tune on the chip but i was able to download them here from the forum. i installed the (s50 s52 3-5 Inch MAF 24# injectors w cams) on the chip, when i tried cranking over for the first time it would just keep cranking and cranking. i had a cylinder fire every once in a while but not enough to get her going. so i grabbed a few friends and we all push started it and it ran fine. i pulled it back into the driveway shut it down and tried again still cranks no start. i could smell fuel coming from the exhaust pipe so i know the injectors are firing and because we were able to get it to push start i know i have spark. so i tried messing with the idle fuel and ignition maps but to no avail, she still cranks her heart out but no start. my current setup is an s50us with 24# injectors euro maf and shcrick cams 272/280. im not the best with software but if one of you could give me a hint in the right direction i believe i would be able to get this lazy old sow off her rump and back on the road! thank you for your time and responses! help is much appreciated!