War Chip Forums

General => General Discussion => Topic started by: Pcmreflash on April 04, 2015, 05:30:36 PM

Title: Is there any injector select table?
Post by: Pcmreflash on April 04, 2015, 05:30:36 PM

Is there any injector select/adjust table on the software? or we have to pay to have that part done if we decided to change injector size?

i don't see any injector flow rate or offset vs volts etc.

Thanks,
Jon.

Title: Re: Is there any injector select table?
Post by: millerperformance on May 21, 2015, 10:26:31 PM

No there is no way for you to select injector size as there is much more to it than simply changing the constant. Because it is far too difficult for 90% of customers, we can provide base tunes for different size injectors if we have developed them in the past. What size do you want to run and for what application?