1
Turbo Tuning / 173 Launch control
« on: September 13, 2013, 09:57:36 PM »
Is the 173 ECU going to have Launch control at any point? or is that not possible?
War Chip Forums
- April 19, 2024, 06:49:40 AM
- Welcome, Guest
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Turbo Tuning / WOT Switch
« on: August 26, 2013, 06:33:31 AM »
Having a little trouble finding info on which wire to cut for the TPS, I know it's the Wire that sends WOT signal but not sure what pin that is. Any help would be appreciated!
89 325i turbo
Thanks
89 325i turbo
Thanks
3
Turbo Tuning / Fueling help!
« on: August 19, 2013, 10:29:59 PM »
Hello, looking for some help here, its also a fuel issue,
setup is:
89 325i
Walbro 255 pump
stock FPR
42lb inj
draw through MAF
Tonight was the first night i tried to start the car after the turbo build and the car wont even consider starting unless the throttle is 100% open and when it does get started it is running so rich it wont idle, not sure what the cranking fuel map is suppose to look like but it just seem way loaded up when i do get it too fire, any help would be great! thanks guys
setup is:
89 325i
Walbro 255 pump
stock FPR
42lb inj
draw through MAF
Tonight was the first night i tried to start the car after the turbo build and the car wont even consider starting unless the throttle is 100% open and when it does get started it is running so rich it wont idle, not sure what the cranking fuel map is suppose to look like but it just seem way loaded up when i do get it too fire, any help would be great! thanks guys
4
General Discussion / Hoemade 4in MAF housing
« on: August 12, 2013, 12:34:17 PM »
My turbo has a 4in intake and i have a 4in intake air filter so i needed a 4in MAF housing so i made one!
5
Projects / My build tread "hoemade"
« on: August 12, 2013, 12:30:07 PM »
Check it out and let me know what you think!
http://www.r3vlimited.com/board/showthread.php?t=290952
http://www.r3vlimited.com/board/showthread.php?t=290952
6
Turbo Tuning / Hello!
« on: August 06, 2013, 01:06:02 PM »
Pretty excited about this, my build is just about done and I may need a little assistance, I have some tuning expirence but im sure there are things im not going to understand, 3076R 60#inj 12psi, Should be a good runner! anyway, this is great! and i look forward to getting to know the guys at miller.
Pages: [1]